1/13/2024 0 Comments L298n for fritzingThat said, this is the same file that I edited last night using Inkscape.92. L9110 H-bridge module_fixed.fzpz (20.0 KB) Comparing the files in this one to your original should tell you all that I changed (if not feel free to ask here ). The pins connecting in the center was because you didn’t have terminals defined (without a terminal the connection is the center of the pin). ![]() Then edited the fpz and cleaned it up (tried omitting the unwanted pins in pcb view but that doesn’t seem to help). ![]() Then (after I discovered Inkscape 9.2 appears to be a bad idea!) I adjusted the box in schematic to center the pins better and added the missing terminal definitions. I also changed all the connectors from the 0 width (that are invisible in Inkscape) to. The broad outline of the changes is that I ungrouped everything in both breadboard and schematic views (many many nested unused groups) then in schematic cleaned out anything that wasn’t an in use connector or a line on the drawing (there are a bunch of unused connectors in there that don’t hurt anything necessarily but are messy). ![]() You have a variety of problems, missing terminal definitions mostly, as usual it was easier to fix them than try and explain how to fix it (although I also don’t know how to fix it so it is happy with the screw terminals).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |